Adapting Microwave Blower For Outside Back Exhaust - Cafe CVM517P Instructions D'installation

To use toggle bolts:
Mounting
Bolt
Wall
3
insert the toggle wings into the holes in the wall
to mount the plate.
NOTE: Before tightening toggle bolts and wood
screw, make sure the tabs on the mounting plate
touch the bottom of the cabinet when pushed
centered under the cabinet.
CAUTION
Be careful to avoid pinching
fingers between the back of the mounting plate
and the wall.
4
to help tighten the bolts.
B3.
USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
You need to drill holes for the top support screws and
a hole large enough for the power cord to fit through.
• Drill the holes, following the instructions on the
CAUTION
Wear safety goggles when
drilling holes in the cabinet bottom.
Installation Instructions
Bolt End
B4. ADAPTING MICROWAVE
BLOWER FOR OUTSIDE BACK
EXHAUST
1 screws
motor to microwave oven.
2
up.
3
blower unit.
BEFORE: Fan Blade
Openings Facing Up
End A
4
Back of Microwave Oven
that holds blower
Screws
Back of Microwave Oven
End B
Back of Microwave Oven
17