Publicité
P4263F
Installation Guide
Introduction
Directional Mounting Arrow
The Directional Mounting Arrow stamped into the top of the P4263F wall
mount indicates which edge is the top.
Wood Stud Installation
1
Minimum of 2 by 4 wood stud to be used
Minimum de 2 par 4 bois goujon pour être utilisé
You must secure the wall plate to two (2) wall studs with a minimum of four (4) lag bolts
(2 lag bolts for each stud found).
Vous devez assembler la sablière sur deux (2) rivets de mur avec un minimum
de quatre (4) tirefonds (2 tirefonds pour chaque rivet trouvé).
1)
Use a stud finder to determine the center of wall studs in the vicinity of the wall plate.
2)
Use a pencil to mark the center of each of the wall studs.
2
1)
Place the wall plate against the wall in the desired viewing location.
2)
Use a pencil to mark the upper right mounting location along the center of
the wall stud.
3
Drill a "pilot hole" in the center of the upper right mark using a 1/4" drill bit and
power drill.
Only use a 1/4" drill bit when drilling the pilot holes.
N'utiliser qu'un foret de 1/4˝ lors du forage de guidage.
Page 4
X
X
Publicité
