Troubeshooting - iDance XD 200 Manuel De L'utilisateur

TROUBESHOOTING

If you have followed the instructions and are having difficulty operating the unit, locate the
PROBLEM in the left column below. Check the corresponding POSSIBLE CAUSE AND SOLUTION
column to locate and fix the problem.
PROBLEM
Noise on speaker output when
microphone is connected and turn on
XD200
Bluetooth cannot connect to XD200
Intermittent Bluetooth music streaming
No sound on selected source
SPECIFICATIONS
AC ADAPTER
SOUND SOURCE INPUT
Total Harmonic Distortion
Signal to Noise Ratio
Speaker Size
Speaker Power Output
Specifications are typical, individual units might vary. They are subject to continuous improvement without
notice and without incurring any obligation.
POSSIBLE CAUSE AND SOLUTION
Make sure your microphone or microphone cable is in good
condition, grounded and shielded. Internal gain of voice
processing could cause vibration from poor ground noise.
Make sure no other device from your friend or family is
connected to XD200. When XD200 Bluetooth is connected,
press BLUETOOTH button would stay ON. So make sure
XD200 indicating Bluetooth is ready to connect. Also make
sure your smartphone / tablet is located close to XD200
less than 2 meters when pairing.
Hold the BLUETOOTH button to reconnect again.
The wireless Bluetooth distance of XD200 is about 7-l0
meter in open area. Below conditions could block you
Bluetooth signal and please ensure you would get rid of
those:
Metal protection on case for your phone/tablet
Metal or wall is blocking in between your phone / tablet
and XD200
Another Bluetooth device is working close toXD200
Ensure that the XD200 is powered ON
Check the master volume on the XD200
Check the volume level on paired Bluetooth device
Remove the power adapter and reconnect again.
AC Input :AC~ 100-240V 50/60Hz
DC Output = 15V , 2000mA
Bluetooth, 1/4 " Microphone, Aux-In
Below 10% at Standard Output
Over 45dB
6.5 "Full range driver X1 + 1.5" Tweeter driver X1
100 Watts
E8