to pull or lift the machine.
19-The machine should never be emersed in
water or a pressure jet of water used for clea-
ning.
20-17- The use of the device is not allowed in
potentially damp areas (for example in the
bathroom) .
21-Periodically examine the mains cable
and machine for damage. If any damage is
found, do not use the appliance but contact
your service centre for repair.
22-If the suplly cord is damaged, it must be re-
placed by the manufacturer, its service agent
or similarly qualified persons in order to avoid
an hazard.
23-Should extension cables be used, ensure
that these lay on dry surfaces and protected
against water jets.
27-Service and repairs must be carried out by
qualified personnel only. Only use manufactu-
rer original spare parts for service repair.
28-The manufacturer cannot be held responsi-
ble for any damage/injury caused to persons,
animals or property caused by misuse of the
appliance, not in compliance with manual in-
structions.
ASSEMBLY
(see fig. ①)
Before using the appliance always check that all
the filters provided are in the correct position
and are properly fitted.
If necessary, fit the cartridge filter 14 in place on
the slots of the dust container 5, and make
sure that, when using the bag 13, the cardbo-
ard flange fits properly into the appropriate
grooves in the dust container itself.
Never use the appliance without Dust Col-
•
lector Filter Bag 13.
Make sure that the upper body 3 is firmly atta-
ched to the lower body 5 and that the clasp 4
is tightly closed.
Fit the hose 7 onto the hose inlet 6 by applying a
slight pressure.
Attach the most suitable accessory to the other
end of the flexible hose.
Apply, in case, the connection adaptor E to match
the proper diameter of any tool in use.
Your appliance is now ready to use.
USAGE
(see fig. ①)
• Be sure that 8 switch is in off position (0) OFF
and connect the machine to a suitable socket.
• The machine must be always kept on horizontal
bases, in a safe and stable way.
• Insert the suitable filters for the proper use.
•
Never use the appliance without filters .
• Use the most suitable accessories for the
requested usage.
• Put 8 switch on (I) ON position in order to start
the machine.
• When job is over, 8 switch off (0) OFF and keep
away the plug 11 from the socket.
Thse unit is equipped with a socket panel
for connection to power tools 9:
•
4C Even when switches are (0) OFF , the electric
tool socket is live.
•
WARNING:
- Observe the maximum connected loads for
the appliance socket (Refer to the SPECIFICA-
TIONS.)
- Make sure that both the cleaner and the elec-
tric power tool are switched off before connec-
ting or disconnecting.
BLOWER FUNCTION
(see fig. ③ ④)
The appliance can also be used as a
blower: fit the blower adaptor D on the exhaust
air outlet 10 by gently pressing.
Fit one terminal part of the flexible hose 7 to the
adaptor and use the other terminal to blow.
CARE AND MAINTENANCE
The unit is maintenance-free.
•
The machine shall be disconnected from its
power source, by removing the plug from the
socket-outlet, during cleaning or maintenance
• Clean the exterior part of the machine with a
dry cloth.
• Move the appliance only by catching the
carrying handle located on the motor head.
• Store the appliance and the accessories in a dry
safe place, out of the reach of children.
For the cleaning and maintenance of the filters,
follow these instructions:
8