Ega Master 79907 Manuel D'instructions page 23

Switch off the machine if it stops - for any reason - to avoid the unexpected starting in uncontrolled
condition.
Do not operate the tool if it is damaged, improperly adjusted or not completely and correctly assembled.
Check hydraulic hose for damage.
Avoid sparks in hazardous environment - created by the drill. Always flush material and drill for cooling with
sufficient water during working.
Do not employ machines by excessive force. Their performance is better and safer, if they work at the
prescribed speed.
Check damaged parts.
Before using the machine, damaged parts or protective devices should be carefully checked to make sure
they work soundly and fulfil the designated function. Check alignment, connections and attachment of moving
parts. Also check if parts are broken. Parts or protective devices that are damaged should, if nothing else is
mentioned in these operating instructions, only be exchanged or repaired by qualified personnel. The same
applies to defective switches and valve triggers. If the machine cannot be switched on or off with the valve
trigger, it should not be used.
The use of other accessories, or other additional items than recommended in these operating instructions,
may include the risk of bodily injury.
Only operate the tool after a thorough training or under supervision of a trainer.
Never exceed the maximum operation pressure.
Follow the valid national provisions in the country of application.
ATTENTION! Never use the hydraulic hose as a lifting handle!
SAFETY INSTRUCTIONS FOR PREVENTION OF WORKPLACE HAZARDS
WARNING – Explosion hazard
Operate the machine according to the intended use only. The machine is designed for the use in areas
exposed to explosion hazards as well. Observe the following:
• Valid local explosion protection directives.
• Technical specifications of the machine.
• Markings on the machine.
• Avoid the generation of sparks.
• When operating the machine, do not push or beat against other material and hold the machine firmly and safely
by hand.
• Do not slide the machine over the ground.
• If heat generation exceeds the specified surface temperature, the machine has to be stopped instantly. It only may
be re-started after having eliminated the cause for the fault.
• The work area and the next working areas should always be protected from sparks.
• Flammable and explosible material has to be removed from the work area before work is started. Among others,
this relates to dust deposits, cardboard, packing material, textile, wood and wooden splints, but also flammable
fluids and gas.
23