Hella marine NAVILED PRO 2LT 959 941 Serie Manuel D'instructions page 2

Lamp positioning
General recommendations
When the lamp is operating, the light should not
be obstructed or concealed by superstructures
or other objects.
Position in relation to vessels centre line
The lamp must be positioned in a vertical
position at a right angle to the vessel's centre
line with the signal direction arrow pointing
straight ahead. (see Fig. 1)
Horizontal positioning
The lamp must be placed forward of amidships
and as far forward as practicable.
(see Fig. 2)
Wiring Colour Coding
LED modules are polarity conscious.
Colour Connect to
Reverse polarity will not damage this product but will inhibit
its function.
Black Negative (-ve)
HELLA recommends wire connections be soldered, and heat
shrink tubing applied to seal the joint.
Red Signal (+ve)
Note: Lamp must be protected by a fuse rated at 3 amperes
maximum.
Fig. 1 Right angle to the vessel's centre line
Top view
Fig. 2 Horizontal positioning
Amidship
Assembly
Step 1 – Make provision for the power cable
Use mounting shroud as a template to drill screw
holes and make provision for the cable.
Screw hole
Cable exit
Screw hole
Step 2 – Mount the Shroud
2.1 Shroud must be installed with markings on
the top horizontal surface.
2.2 Arrow on top of shroud must point straight
ahead.
2.3 Fix shroud with two M5 or 10 gauge fasteners.
Markings on the top
Use marine grade
stainless steel fasteners
with a wide flat head
(not included)
Step 3 – Insert the optic assembly
Note: Arrow on top of shroud and arrow on top of
optic assembly must point in the same direction.
3.1 Feed power cable through shroud
3.2 Push optic assembly into shroud
3.3 Connect power
Shroud
Optic Assembly
Removal
Step 1
Carefully insert 2 screw drivers between
optic assembly and shroud.
Step 2
Pull optic assembly out.
Note: Do not open. No servicable parts
inside.
www.hellamarine.com