Motor part becomes warm
Motor vibrates
Motor has a very loud noise
6.
Others
6.1.
Environmental Protection and Disposal
The owner has a duty to dispose of the clipper blades as well as of the clipping machine proper-
ly at the end of its service life. Please observe your relevant national regulations.
6.2.
Declaration of conformity
This device complies with the requirements of the following EU directives:
2004/108/EG
2006/95/EG
Air filter is blocked; air can no
longer circulate
Shearing tension too high
clipping
Motor bearing defective
Broken fan
Bearings are worn out
Seized bearings
Page 17
Remove air filter and clean
with brush or replace filter
Do not tighten pressure tensi-
on nut so much.
If the blades still do not cut,
they should be resharpened
or
replaced
Have the motor replaced
Have it repaired by service
centre
Have the motor replaced
Have it repaired by service
centre
EN