Switching On / Off - Lister 1300-2-TD Mode D'emploi

machine and keep it away from hot surfaces and objects. This may result in breaks and
EN
damage to the insulation. The cable should be regularly checked for damage.
• Switch the machine to OFF (Position 0) before pulling out the plug.
• Wear suitable work clothes. Do not wear any loose fitting clothing or items of jewellery
which could get caught up in moving machine parts. We would recommend in the stron-
gest terms that protective goggles and ear protectors are worn.
• Never insert any object into any of the machine's apertures.
• Noise from the machine can worry animals. Considerable injury can be caused as a result
of being kicked by an animal or being crushed by its body weight. Tether the animal secu-
rely, approach it from in front and switch the machine on within the animals' range of vision.
• Animals should only be clipped if unauthorised persons have been excluded from the
clipping area.
• Only clip in well-ventilated spaces (dust) and never near objects or gases likely to explode.
• Generally, never plunge the clipper and clipperhead into liquids such as water, soapy water,
diesel, petrol, etc. This may cause serious injury to mechanics and motor.
These safety notes must be complied with in all cases. It is recommended that a
fault current safety plug always be used when working with electrical equipment.
3.2.
The switch has two positions.
Position 0: Machine switched off
Position I: Machine switched on
Always use the switch when switching the machine on and off. Check the switch position before
plugging in the cable.
3.3. Failure - Motor protection switch
If your machine features an overload protection switch, the motor is protected against inadmis-
sible mechanical and thermal overloading. It may happen that this switch releases after a hard
hit and must be pushed in again.
If your machine does not feature an overload protection switch then your machine possesses an
automatic overload electronics. If the machine in operation switches off automatically, one of the
following causes may be the reason:

Switching On / Off

Page 14