Troubleshooting - Stinger ISANTA CN100B Mode D'emploi

DISCONNECT THE AIR HOSE FROM THE TOOL WHEN
PERFORMING INSPECTIONS, MAINTENANCE, OR REPAIRS.
PROBLEM
1. Tool operates, but no fasteners are driven
2. Cap leaks air
3. Fasteners jam in nose of tool
4. Weak drive
5. Skipping fasteners
6. Fasteners will not drive completely into
work piece
Please contact Inside Sales for technical support if you have any other problems
TROUBLE SHOOTING
CORRECTION
• Make sure the tool is lubricated.
• Check Magazine for proper fasteners.
Fasteners should move freely in and out
of the Magazine.
• Tighten Cap Screws
• Depress the latch on the Nail Gate and
Basket Cover. Open the Nail Gate and Basket
Cover. Remove the jammed fastener.
• Reload tool
• Close Nail Basket cover and Nail Gate.
• Check to make sure there is adequate
air supply
• Replace Bumper if worn
• Use only genuine STINGER
• Replace Magazine if worn
• Check air supply as it may be too low or
too high
• Make sure tool is lubricated
• Adjust the depth of drive
• Check air supply as it may be too low or
too high
• Inspect Driver Blade for damage
800-746-5659
NailPac
® ®
12