MTech XENON LED KIT Notice De Montage page 4

6. After installation of all cables and ballasts, check if your new xenon lights work correctly.
Warning: If both lights do not turn on at the same time, replace the battery with a more powerful one with
a capacity of 60Ah because the problem may be too small tension of ballasts. Replace fuses of headlights to have a
value of at least 20A.
DO NOT TURN ON THE LIGHTS BEFORE CONNECTING TO BALLASTS!
| 4
4. Reinstall the plastic
a drilled hole and seal connection with rubber ring
installed on the cables.
5. Install connection following the picture. Install ballasts in the
nearest possible place next to the reflector using cable ties or
attached coasters. Remember to locate high-voltage cables
away from other electrical wirings. Otherwise, there may appear
interference in electronic systems of the vehicle.
7. IF YOU HAVE BIXENON H4-3 in order to make it work
correctly, connect the additional wiring harness which
is included in the set. The set is powered directly by an
accumulator, through the additional wiring harness and
electronic control system. Red cable in the wiring harness
is „+" (with fuse, 1 pc), connect it to the battery. Each bal-
last, separately, has a ground wire. You need to connect
both wires to „-„ of the accumulator. Brick of the wiring
harness has to be connected to one of the H4 bulb sockets,
located in the headlight of the car.
WARNING!!!
cover after putting wires in