Installation Process - MTech XENON LED KIT Notice De Montage

Mounting instruction.
Manual
Please read these instructions carefully before starting the installation. We assume no liability for any damage
caused by not following the instructions below.
1. Start the installation after making sure that the engine and the bulbs are cold enough to avoid burns.
2. Durning the installation the light switch must be off.
3. Do not drop, scratch or stain xenon bulbs durning the installation process.
4. Check the voltage source, all connections and cables for their effinency in order to avoid problems with the inclu-
sion and use of the lights.
5. Make sure that ballasts do not change the polarity
6. Install ballasts away from heat source, which is the engine, to not damage them.
7. Ballasts must be well grounded.
8. Ballast should stick to metal part of a car.
9. Use the attached metal clamps durning the installation process. The use of velcro, cable ties
or double-sided tapes may cause interference.
10. Ballast's cables should not be intertwined with any other cables. The ballast should be mounted
as close to the bulb as possible.

Installation process

1. Remove the old halogen lamp located in the back of the
reflector (after removing the plastic cover).
2. Drill a 25mm hole in the plastic cover.
3. Remove the plastic cover from the bulb and install it
in the place of the removed halogen bulb using the
same element (wire) as when installing a halogen bulb.
Warning: Make sure that glass part of the xenon bulb is not
dirty. If so, clean it with a dry cloth and alcohol.
3 |