Bestgreen BG 2525 Manuel D'utilisation page 33

8
EN
An analysis of accidents with these saws during tree ser-
vice operations shows the primary cause as being inap-
propriate one-handed use of the saw. In the vast majority
of accidents, operators fail to adopt a secure work posi-
tion witch allows them to hold both handles of the saw.
This results in an increased risk of injury due to:
• not having a firm grip on the saw if it kicks back;
• a lack of control of the saw such that it is mo re liable to
contact climbing lines and operators body (particularly
the left hand and arm)
• losing control from insecure work position re sul ting in
contact with the saw (unexpected mo vement during
operation of the saw).
Securing the work position for two-handed use
To allow the operator to hold the saw with both hands,
they should as general rule, aim for se cur e work position
where they are operating the saw at:
• hip level when cutting horizontal sections;
• solar plexus level when cutting vertical sections.
Where the operator is working
close into vertical stems with a
low lateral forces on their work
position, then a good footing
may be all that is needed to
maintain a secure work posi-
tion.
However as operators mo ve
away from the stem, they will
need to ta ke steps to remove
or count er act the increasing
la teral forces by, for ex am ple,
a re-direct of the main line via
a supplementary anchor point
or using an adjustable strop
direct from the harness to a
supplementary an chor point.
Gaining a good footing at the
working position can be as-
sisted by use of a temporary
foot stirrup crea ted from an
endless sling.
Starting the saw in the tree
When starting the saw in the tree, the operator should:
a) apply the chain brake before starting;
All manuals and user guides at all-guides.com
b) hold saw on either the left or right of the body when
1) on the left side hold the saw with either the left hand
2) on the right side, hold the saw with the right hand on
The chain brake should always be engaged before lower-
ing a running saw onto its strop. Operators should always
check the saw has sufficient fuel before undertaking criti-
cal cuts.
One-hand use of the
chainsaw
Operators should not use
tree service chainsaws
onehanded in place of
unstable work positioning
or in preference to a hand-
saw when cutting small di-
ameter wood at the branch
tips.
Tree service chainsaws
should only be used one-handed where:
• the operator cannot gain a work position enabling two-
• they need to support their working po sition with one
Operators should never:
• cut with the kickback zone at the tip of the chainsaw
• "hold and cut" sections
• attempt to catch falling sections.
Freeing a trapped saw
If the saw should become trapped during cutting, opera-
tors should:
• switch off the saw and attach it securely to the tree
• pull the saw from the kerf whilst lifting the branch as
• if necessary, use a handsaw or second chain saw to
Whether a handsaw or a chainsaw is used to free a stuck
saw, the release cuts should always be outboard (toward
the tips of the branch), in order to prevent the saw be-
ing taken with the section and further complicating the
situation.
SAFETY REQUIREMENTS
starting:
on the front handle or the right hand on the rear handle
and thrust the saw away from the body while holding
the pull starter cord in the other hand;
either handle and thrust the saw a way from the body
while holding the pull star ter cord in the left hand.
han ded use; and
hand; and the saw is being used at full stretch, at right
angles to and out of line with the operator's body.
guide bar
inboard (i.e. towards the truck side) of the cut or to a
separate tool line;
necessary;
release the trapped saw by cutting a mi nimum of 30 cm
away from the trapped saw.