Installation - Veripart VPKVC180W Notice D'utilisation

3. INSTALLATION

Before installing the refrigerator, carefully review the safety information
(section 1).
1. Unpack
Remove the packaging materials and dispose of them properly. Check
that the appliance is not damaged. Do not connect the appliance if it
is damaged. Report any damage immediately to the salesperson via
customer service. In that case, keep the packaging.
2. Wait
Wait four hours before connecting the appliance so the oil can flow
back to the compressor.
3. Clean
Clean the interior and all internal accessories with lukewarm water
and some neutral soap before first use to remove the typical smell of a
brand new appliance. Dry everything carefully.! Do not use solvents or
abrasive powders; these will damage the coating
4. Location
The location where you place your appliance should be well ventilated
and the air should not be too warm. Do not place the appliance near a
heat source, such as a stove or boiler, and avoid direct sunlight, so that
as to guarantee the cooling effect and save on energy consumption. Do
not place the appliance in a damp place so that it cannot rust and there
is no leakage current.
5. Heat dissipation area
During operation, the appliance emits heat to the environment. Therefore
there must be at least 5 cm clearance on the top, at least 5 cm on both
sides and at least 5 cm on the back of the fridge. (see page 47)
49