Removing The Handles; Installing The Handles - GE 21 Manuel D'utilisation Et D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Installing and removing previously installed decorator panels.
Read these instructions completely and carefully.

Removing the Handles

In order to remove the decorator panels and replace
with new panels you need to remove the handles.
A T-20 Torx driver is needed.
Loosen and remove the 2 screws in the
1
Top Trim.
Loosen and remove the 2 screws in the bracket
2
that attaches the Handle to the top of the Door.
Grip the Handle firmly and slide upwards.
3
The keyhole slots on the Handle slide off the
buttons on the door.
Open the door and slide out the decorator
4
panels.
Inserting the Door Panels
Before installing the decorator panels, make sure they have been routed out in the proper areas as shown in the
beginning of this section. Slide in the panels to perform a trial fit before fastening down the Handle and Top Trim.

Installing the Handles

Once the panels are fitted properly, install the Handle and Top Trim.
Slide the keyhole slots on the Handle down onto
1
the buttons mounted to the face of the door.
Slide the Handle downward until the bracket at
the top of the Handle fits flush on the top of
the door.
Replace the two screws in the bracket that attach
2
the Handle to the top of the Door and tighten
the screws to 45 in-lbs torque.
22
Top Trim Screws
Buttons
Button
Replace the Top Trim making sure it fits over
3
the Side Trim and that the locating tabs fit the
inside of the Handle profile.
Replace the Top Trim screws and tighten to
4
30 in-lbs torque.
Bracket Screws
Bracket
Slots
Slot

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

23252729Pss25mgmbbb

Table des Matières