Troubleshooting - Klarstein HOT SPRING PLUS Manuel D'utilisation

Preparation for storage
1. Unplug the appliance.
2. Open the hot water dispenser and
take out the inner pot (water tank).
3. Drain out all of the water in inner pot.
Install water receiver
• Put the grid on the water receiver
and push the water receiver into the
support from above.

TROUBLESHOOTING

Problem
White or glittery powder
inside the water
Bad smell occurs after
boiling
Dispense function does not
work just after boiling
Water drain mark
Possible Cause
There is limescale in the
water.
The tap water may contain
to much minerals which
stick on the inner pot
surface as limescale.
Chlorine in tap water may
cause smell after boiling.
The machine oil on the heating element
may cause smell in first few use.
If the air pot is used on plastic cloth,
smell of plastic may transfer into water.
Check if the filter is
clogged.
The dispense function may
be affected by bubbles
inside the pump.
Possible Solution
Clean the appliance with
citric acid.
Clean the appliance with
citric acid.
Press the "Reboil" button
to reboil.
Clean the filter with a
brush.
Please open and close the
lid once then try again.
EN
29