Porter Cable FC350B Manuel D'instructions page 9

1. Read all Safety Warnings before using tool.
2. Connect the air supply to the tool.
3. Insert fasteners (L) into T-slot (K) on end cap
of magazine (J) past the nail stop (E). nOTe:
Magazine will hold two full fastener strips.
4. Pull pusher (I) back until the nail stop (E) falls
behind the fasteners.
nOTe: Do not allow the pusher to snap forward
against the nail strip, allowing this to happen could
damage the nail collation.
nOTe: This tool has a low nail lock out device which
will not allow the tool to drive fasteners when the fastener quantity in the magazine is
reduced to four. When unloading and loading the magazine always make sure these
four nails have been removed from the magazine. If the nails are not removed from the
magazine and the tool is reloaded and actuated, the nails will cause the tool to jam.
Fig. 3
l
ACTUATInG TOOl
To reduce the risk of injury, AlWAyS wear proper eye ANSI Z87.1
(CAN/CSA Z94.3) and hearing protection ANSI S12.6 (S3.19)］when operating this tool.
The tool can be actuated using one of two modes: single sequential actuation trigger
mode and contact actuation trigger mode.
Single Sequential actuation trigger -
Allow the tool to recoil off the work
surface after actuation. If the contact trip remains
depressed a nail will be driven each time the trigger is
released and pulled, which could result in accidental
actuation, possibly causing injury.
The sequential actuation trigger's intended use is
for intermittent fastening where accurate fastener
placement is desired.
To operate the tool in Single sequential actuation
mode:
1. Depress the contact trip firmly against the work
surface.
2. Pull the trigger.
3. Allow the tool to recoil from the work surface.
e
Fig. 2
Fig. 4
(Fig. 5)
Fig. 5
S
Trigger mode selector button
9 - ENG
l
K
D
J
I H
l
Trigger lock button