Replacement Parts - Porter Cable FC350B Manuel D'instructions

Disconnect air line from tool, engage trigger lock and remove
fasteners from magazine before making adjustments or personal injury may
result.
DAIly MAInTenAnCe CHART
ACTIOn
Lubricate tool with 5-7
drops of PORTER-CABLE
Pneumatic Tool Oil
Drain compressor tanks
and hoses daily
Clean magazine, magazine
release and contact
trip mechanism.
Before each use, check
to insure all screws,
nuts and fasteners are
tight and undamaged.
CleAnInG
Never use solvents or other harsh chemicals for cleaning the non-
metallic parts of the tool. These chemicals may weaken the materials used in these
parts. Use a cloth dampened only with water and mild soap. Never let any liquid get
inside the tool; never immerse any part of the tool into a liquid.
RepAIRS
For assistance with your tool, visit our website at www.portercable.com for a list of
service centers, or call the PORTER-CABLE Customer Care Center at 1-888-848-5175
(U.S. & Canada Only).

ReplACeMenT pARTS

Use only identical replacement parts. For a parts list or to order parts, visit our service
website at http://servicenet.deltaportercable.com/. You can also order parts from
your nearest PORTER-CABLE Factory Service Center or PORTER-CABLE Authorized
Warranty Service Center. Or, you can call our Customer Care Center at 1-888-848-5175
(U.S. & Canada Only).
SeRvICe AnD RepAIRS
All quality tools will eventually require servicing and/or replacement of parts. For
information about PORTER-CABLE, its factory service centers or authorized warranty
service centers, visit our website at www.portercable.com or call our Customer Care
Center at 1-888-848-5175 (U.S. & Canada Only). All repairs made by our service centers
MAInTenAnCe
WHy
Prevents failure
of o-rings
Prevents accumulation
of moisture in
compressor and nailer
Permits smooth
operation of magazine,
reduces wear and
prevents jams.
Prevents jams, leaks
and premature failure
of tool parts.
SeRvICe
13 - ENG
HOW
Insert drops into air fitting
on end cap of tool
Open petcocks or other
drain valves on compressor
tanks. Allow any accumulated
water to drain from hoses
Blow clean with compressor
air. The use of oils, lubricants
periodically or solvents is
not recommended as they
tend to attract debris.
Tighten loose screws or other
fasteners using the appropriate
hex wrench or screwdriver.