Connecting The Tv Signal Source To An Existing Setup - Asus Asteio D22 Mode D'emploi

Connecting the TV signal source to an existing setup

This section describes how to connect the Media Center PC to an existing setup for your TV signal
source.
Wall to VCR to TV using coaxial cable
Remove the coaxial cable at the input to the VCR, and connect it to the input of a coaxial cable signal
splitter ( not included). Connect two coaxial cables to the splitter outputs.
Connect one of these cables to the input of the VCR and the other to the TV connector on the back of
the Media Center PC.
Existing setup
C
A
B D
Connect to PC
C
A
B G
A Wall
B Cable outlet
C Coaxial cable
D VCR In
E VCR Out
F TV In
G Splitter In
H Splitter Out
I TV In jack on the back of the Media Center PC
10 Asus Media Center PC
C
E
C
H I
RECORDER D V D + R D L
H
C
D
E
F
C
F
Note:
Splitters are not included.