Herth+Buss Reanimator 1400 Mode D'emploi page 20

Starthilfe, akku-betrieb
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Operating Instruction
1. Open the protective cover of the DC output
on the front of the Reanimator.
EN
2. Connect the device to the 12 V socket.
Please note:
The maximum power of the 12 V
socket is 150 W.
The DC output is directly wired to the in-
stalled battery. Long operation of a 12 V
device may cause the battery to discharge
excessively. Charge the battery again imme-
diately after disconnecting the device.
4.5 USB port and work light
By turning the switch (1) to position I (TEST/
USB) or position II (LIGHT/USB), the USB
port will switch on. If the battery has less
than 10 V voltage, the USB port will switch
off automatically.
1. Switch position I (TEST/USB): If the switch
is in this position, the USB port will switch
on and the status of the battery will be dis-
played.
2. Switch position II (LIGHT/USB): If the
switch is in position II, both the USB port
and the work light will switch on.
WARNiNG
Never shine the light directly or indi-
rectly in your own eyes or the eyes of
other people or animals via
reflective surfaces!
www.herthundbuss.com
All manuals and user guides at all-guides.com
5. Charging the installed
Reanimator battery
You can check the state of the installed bat-
tery by actuating the switch (1). The status is
displayed via the LED displays (7), (8) and
(9). If LED (8) or (9) lights up, charge the
Reanimator again. The Reanimator should
be charged after every use. Charge at least
every 6 months if it has not been used in a
long time.
Please note:
If the voltage of the internal battery falls
below 8 V, the red LED (9) starts to flash
and an acoustic alarm sounds. The de-
vice can no longer be used in this state
and must be fully charged. If the voltage
falls below 7 V, the device switches itself
off automatically and can only be restar-
ted after being fully charged.
1. Only charge the installed Reanimator bat-
tery using the charger contained in the
scope of supply.
iMPoRTANT
Only use the charger supplied with the
Reanimator to charge the installed Re-
animator battery. The use of another
charger for different purposes may
lead to injury or material damage.
95980700
20

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

95980700

Table des Matières