Display Screen; Testing Your Blood Pressure Before Measurement; Fitting The Cuff Properly - Fora Vital TD-3124B Manuel De L'utilisateur

Display Screen

1
2
3
1. Test Result
2. Memory Mode Symbol
3. Low Battery Symbol
4. Pulse Rate Symbol
5. Pulse Rate
TESTING YOUR BLOOD PRESSURE
Before Measurement
• Avoid caffeine, tea, alcohol and tobacco for at least 30
minutes before measurement.
• Wait 30 minutes after exercising or bathing before
measurement.
• Sit or lie down for at least 10 minutes before measurement.
• Do not measure when feeling anxious or tense.
• Take a 5-10 minute break between measurements. This
break can be longer if necessary, depending on your
physical condition.
• Keep the records for your doctor as reference.
• Blood pressure naturally varies between each arm. Always
measure your blood pressure on the same arm.
4

Fitting the Cuff Properly

5
Pile Side Material
2~3cm
EN-4
1. Connect the air plug of the tubing to
the air jack of the meter.
2. Assemble the cuff as shown on the
Sewn Hook Material
right. The smooth surface should be
inside of the cuff loop and the metal
D-ring should not touch your skin.
D-Ring
3. Stretch your left (right) arm in front
Main Arteries
of you with your palm facing up. Slide
and place the cuff onto your arm to let
the air tube and artery mark region (in
red) toward the lower arm.
Wrap and tighten the cuff above your
elbow. The red line on the edge of the
cuff should be approximately 2 cm to
3 cm (0.8" to 1.2") above your elbow.
Align the tube over the main arteries
on the inside.