INTRODUCTION
The White-Rodgers Air Cleaner Compartment comes com-
plete with a 5" media furnace air filter. This filter must be
changed every three months to maintain efficiency of the filter
and furnace system. For maximum efficiency, the compart-
ment can be upgraded to a White-Rodgers Electronic Air
Cleaner.
Please read instructions before installing and using the Air
Filter Compartment.
L
CAUTION
!
The fiber filter used in this cabinet for air cleaning
must be replaced every 90 days. Your heating and
cooling efficiency will decrease due to insufficient
air flow when filter becomes dirty.
L
WARNING
!
Do not attempt installation of this unit unless you
are familiar with the necessary tools, equipment,
and potential hazards.
Installation should be performed only by a qualified
service provider.
Failure to do so could result in reduced performance
of the unit, serious personal injury or death.
TABLE OF CONTENTS
Installation ............................................................ 6
Maintenance ......................................................... 7
BASIC TOOLS REQUIRED
Tin Snip
Screwdriver
Rule or Tape Measure
Drill
GUARANTEE
White-Rodgers will not assume any responsibility for
component failures due to incorrect installation procedures.
RULES FOR SAFE INSTALLATION
AND OPERATION
1. Read the Owners Manual and the Rules for Safe
Operation carefully. Failure to follow these rules and
instructions could cause a malfunction of filter or
unsatisfactory service.
L
!
Installation of this unit must comply with local
electric codes or other applicable codes.
Review and understand local codes prior to
installation.
Before installing or servicing, always
shut off electricity. This will prevent
any electrical shocks.
2. Follow a regular service and maintenance schedule
for efficient operation.
DID YOU GET THE RIGHT SIZE
AIR FILTER COMPARTMENT
Model ACB & ACM1000 are designed for heating or
cooling blowers delivering 600 to 1200 cubic feet of air per
minute (cfm.)
Model ACM1200TM is designed for heating or cooling
blowers delivering 1000 to 1600 cfm.
Model ACB & ACM1400 are designed for heating or
cooling blowers delivering 1000 to 1600 cfm.
Model ACB & ACM1600 are designed for heating or
cooling blowers delivering 1200 to 1800 cfm.
Model ACB, ACM2000 & ACM2000X are designed for
heating or cooling blowers delivering 1600 to 2200 cfm.
Model ACM2000U is designed for heating or cooling
blowers delivering 1600 to 2200 cfm. with insulation on
door and universal rail.
Before installing the filter, make sure you have selected
the proper size unit for your heating and cooling system
requirements. See specifications on page 4.
2
WARNING
L
WARNING
!