Recommended Maintenance Schedule - Ninebot KickScooter Manuel Du Produit

EN

Recommended Maintenance Schedule

5
To ensure safe riding, day to day care and regular maintenance are essential. You, the owner, have control and knowledge of
how often you use your scooter, how hard you use it and where you use it. It is the owner's responsibility to perform regular checks
and bring your scooter to authorized service center for inspection and service. Please refer to the maintenance schedule
below.
Note: This maintenance schedule charges a service fee.
Item Component Maintenance Method
Mainframe parts Use a soft, wet cloth to wipe the mainframe clean.
Inflate tires to 40–45 psi. Note: Remember to screw
Tire pressure
the valve cap after inflating!
Check if the tires are cracked, deformed, or
Tire wear
significantly worn.
Tighten the six screws fixed with the handlebar and the
stem. The suggested torque is 3.0±1.0 N·m.
Tighten the screw on the throttle. The suggested
Mainframe
Screws on the
torque is 2.0 N·m.
maintenance
stem top
Tighten the screws on the brake levers. The suggested
torque is 7–9 N·m.
Tighten the screws on the stem top. The suggested
torque is 10±0.5 N·m.
Tighten the two screws fixed with the front fork and the
folding mechanism. The suggested torque is 10±1 N·m.
Screws on the
folding If the stem gets shaky when riding, tighen the screws on the
mechanism
folding mechanism when the scooter is in folded state.The
suggested torque is 15±1 N·m.
06
Every 6 After 2 years or
months or the total
Every 3
every 310 mileage > 3107
months
miles (500 miles (5000
km) km)
√ √ √
√ √ √
√ √
√ √ √
√ √
√ √
Item Component Maintenance Method
To accelerate and decelerate, check if the hub motor is stalled
Hub motor
or has abnormal sounds.
Rear wheel Check if the rear wheel is stalled or gets shaky, or the axis shaft
is unbalanced.
maintenance
If the brake is too loose/tight, tighten/loosen the adjusting
Brake
screw on the drum brake clockwise/counterclockwise to
adjustment
adjust its position.
Taillight Squeeze the brake lever, the taillight works normally.
Headlight Check the headlight and see if it lights brightly.
Direction Toggle the direction indicator button to the left/right
indicators
respectively, check if the direction indicators on the left/right
side flash normally.
Function
Dashboard Power on the scooter, the dashboard works properly.
Inspection
Bell Ring the bell, the sound should be loud.
Press and hold the throttle, then release it, checking for
Throttle
acceleration and deceleration.
After connecting with the Segway-Ninebot app:
1) Update the firmware to the latest version.
app
2) Check if the notification of the corresponding error code and
detection
possible causes will prompt when the scooter detects an error.
Charge the scooter:
1) Check if the current battery power displays on the dashboard.
Charging
2) Check the LED indicator on the battery charger.
Charging: red, Fully charged: green.
Buttons Press or toggle the button 3 times without failure.
Test with left turns and right turns (the steering angle is 60).
Steering
No resistance or lag when turning.
EN
Every 6 After 2 years or
months or the total
Every 3
every 310 mileage > 3107
months
miles (500 miles (5000
km) km)
√ √
√ √
√ √
√ √
√ √
√ √
√ √
√ √
√ √
√ √
√ √
√ √
√ √
07