cecotec DRESSCODE 8600 INVERTER Manuel D'instructions page 34

ENGLISH
Cleaning the detergent dispenser
Press down the arrow on the softener cover inside the dispenser drawer.
Lift the clip up and take out the softener cover and wash all grooves with water.
Replace the softener cover and push the drawer into position.
Pull out the dispenser drawer by pressing the A. Fig. 29.
Clean the dispenser drawer under running water. Fig. 30.
Clean inside the recess with an old toothbrush. Fig 31.
Insert the dispenser drawer. Fig. 32.
Warning: Do not use alcohol, solvents or chemical products to clean the washing machine.
Cleaning the drain pump filter
Warning:
Be careful with the hot water!
Allow detergent solution to cool down.
Unplug the machine to avoid electrical shock before washing.
The drain pump filter can filter the yarns and small foreign matters from the washing.
Clean the filter periodically to ensure proper operation of the washing machine.
Open the lower cover cap. Fig. 33.
Rotate 90 °C and pull out the emergency drain hose and take off the hose cap. Fig. 34.
When it is fully emptied, reset the drain hose. Fig. 35.
Open the filter by turning it counterclockwise. Fig. 36.
Remove dust, dirt and other substances or objects. Fig. 37.
Close the lower cover cap. Fig. 38.
Warning:
Make sure that the valve cap and emergency drain hose are reinstalled properly, cap plates
should be inserted aligned to the hole plates.
*Some machines don have emergency drain hose, so step 2 and step 3 can be skipped.
Rotate the lower cover cap directly for water to run into the basin.
When the appliance is in use and depending on the programme selected there can be hot
water in the pump. Never remove the pump cover during a wash cycle, always wait until the
appliance has finished the cycle and is empty.
When replacing the cover, ensure it is securely re-tightened.
66
6. TROUBLESHOOTING
Problem Cause
The washing machine does The door is not closed
not start up properly
The door does not open The safety lock system is
activated
Water leakage Bad connection between
pipes and water supply
hose or drainpipe.
Detergent residues in the box Detergent is dampened or
agglomerated
Indicator or display does not The power PC board is
light disconnected, or harness
has connection problem
Abnormal noise
Errors
Error Cause
E30 Door is not closed
properly
E10 Water injecting problem
while washing
E21 Overtime water draining
E12 Water overflow
BOLERO DRESSCODE_8600 INVERTER / 9600 INVERTER / 9600 INVERTER STEEL / 12600 INVERTER
ENGLISH
Solution
Restart after the door is
closed.
Check if there are clothes
stuck.
Unplug it and restart the
product.
Check and fasten water pipes
and hose.
Clean up outlet hose.
Clean and wipe the detergent
box
Check if the power is shut
down and the power plug is
connected correctly.
Check if the fixing bolts have
been removed.
Make sure the appliance is
installed on a solid, level
floor.
solution
Restart after the door is
closed.
Check if there are clothes
stuck.
Check if the water pressure is
too low.
Straighten the water pipe.
Check if the inlet valve filter is
blocked.
Check if the drainpipe is
blocked.
Restart the appliance.
67