Product Installation - cecotec DRESSCODE 8600 INVERTER Manuel D'instructions

ENGLISH

3. PRODUCT INSTALLATION

Place the device on a flat, stable and dry surface. Make sure the product does not stand on the
power cord.
Fig. 3.
Avoid direct sunlight and ensure sufficient ventilation.
Fig. 4.
Remove the cardboard box and Styrofoam packing.
Lift the washing machine and remove the base packing. Make sure the small triangle foam is
removed with the bottom one together. If not, lay the unit down with on the side surface, then
remove the small foam from the unit bottom manually.
Fig. 5.
Remove the tape securing the power supply cord and drain hose.
Remove the inlet hose from the drum.
Removing the transport bolts
The transport bolts must be removed from the backside of the device before using it.
The transport bolts will be necessary again when moving the product, so make sure they are
kept in a safe place.
In order to remove the bolts:
Fig. 6.
Loosen 4 bolts with a spanner and then remove them.
Stop the holes with transport hole plugs.
Keep the transport bolts properly for future use.
Levelling the washing machine
Warning: The lock nuts on all four feet must be screwed tightly against the housing.
Check if the legs are closely attached to the cabinet. If not, please turn them to their original
position and tighten the nuts.
Loosen the lock nut to turn the feet until it closely contacts with the floor.
Adjust the legs and lock them with a spanner, make sure the machine is steady.
Fig. 7.
Water supply hose connection
Warning: Do not kink, crush, modify or sever the water inlet hose.
For the models equipped with hot valve, connect it to a hot water tap with the hot water supply
hose. Energy consumption will decrease automatically for some programs.
Connect the inlet hose following one of the below methods:
Connection between ordinary tap and inlet hose.
Fig. 8.
56
Loosen the clamp nut and four bolts.
Tighten the clamp nut.
Press slide bushing and insert inlet hose into connecting base.
Connection finished.
Connection between screw tap and inlet hose. Fig. 9.
Tap with threads and inlet hose.
Special tap for washing machine.
Connect the other end of inlet hose to the inlet valve at the backside of product and fasten the
pipe tightly clockwise. Fig. 10.
Drain hose
Note: Do not kink or protract the drain hose.
Position the drain hose properly, at 60-90 cm from the floor.
There are two ways to place the end of the drain hose:
In a drainpipe. It is recommended to use a vertical tube.
In a sink's drainpipe, over the trap.
Fig. 11.
If the machine has drain hose support, it can also be installed on a sink or a tank, like the
following. Fig. 12.
Warning: When installing drain hose, fix it properly with a rope. If drain hose is too long, do not
force it into washing machine as it will cause abnormal noises.
4. OPERATION
Note:
Please make sure the appliance is properly installed before operating it.
Run one whole cycle while the appliance is empty before using it for the first time.
Calibration
It is recommended to calibrate the appliance. To do so:
Empty the washing machine.
Plug it in.
Turn the appliance on and press Speed and Delay at the same time within 10 seconds. The
display will show "t19".
Press the Start/Pause button for the appliance to start washing. The display will show "****".
BOLERO DRESSCODE_8600 INVERTER / 9600 INVERTER / 9600 INVERTER STEEL / 12600 INVERTER
ENGLISH
57