Publicité
Liens rapides
TEMPLATE MG1200/MG1200DT
DRILL 18 mm HOLE
(23/32")
(DO NOT DRILL UNIL STEP 3)
PLACE AGAINST JAMB.
OPPOSITE HINGES FOR
L.H.R. DOOR INSTALLATION
*PLEASE SEE LOCK USER'S GUIDE FOR INSTALL INSTRUCTIONS*
NEW INSTALLATION
STEP2
＊
WASHERS(THE RUBBER WASHER AND 2 STEEL)
ON THE THROUGH
NOTE 1
• REFERENCE THE FIGURE ABOVE FOR HOLE PATTERN FOR A NEW
INSTALLATION (USE HOLES MARKED WITH "X")
PLACE AGAINST HEADER
FOLD ON THIS LINE
PLACE AGAINST DOOR
6 mm DIA. ARMATURE GUIDE PIN HOLES-12.5mm DEEP
(1/4")
LOCK MOUNTING PLATE DETAIL
SEX NUT
(1/2")
DRILL 16mm
ARMATURE MOUNTING HOLE
RETROFIT INSTALLATION
A
E
B
NOTE 2
• TWO SCREWS MUST BE MOUNTED IN LOCATIONS "B", USING
HOLES FROM PREVIOUS INSTALL IF NECESSARY.
• AVOID ANY HOLES FROM PREVIOUS INSTALL (EXCLUDING THE
SCREWS IN LOCATIONS "A" & "B"). INSTALL AT LEAST 2 SCREWS
IN SECTION "C" AND AT LEAST 3 SCREWS IN SECTION "D".
• AT LEAST 1 SCREW MUST BE IN LOCATION "E".
(1/8")
DRILL 3.2 mm HOLE
(2 PLACES)
PLACE AGAINST JAMB.
OPPOSITE HINGES FOR
R.H.R. DOOR INSTALLATION
(11/16")
IN-
C
D
47259094 Rev.07/19-b
©Allegion 2019
Publicité
Manuels Connexes pour Allegion Locknetics MG1200
Sommaire des Matières pour Allegion Locknetics MG1200
- Page 1 • REFERENCE THE FIGURE ABOVE FOR HOLE PATTERN FOR A NEW HOLES FROM PREVIOUS INSTALL IF NECESSARY. INSTALLATION (USE HOLES MARKED WITH “X”) ©Allegion 2019 • AVOID ANY HOLES FROM PREVIOUS INSTALL (EXCLUDING THE 47259094 Rev.07/19-b SCREWS IN LOCATIONS "A" & "B"). INSTALL AT LEAST 2 SCREWS IN SECTION "C"...
- Page 2 GABARIT MG1200/MG1200DT À PLACER CONTRE LE LINTEAU GABARIT PERCER UN TROU DE 3,2 mm (0,13 po) (2 emplacements) PERCER UN TROU DE 18,2 mm (0,71 po) PLIER LE LONG DE LA LIGNE POINTILLÉE À PLACER CONTRE LE MONTANT À PLACER CONTRE LE MONTANT À...