Horizon Global 76592 Instructions D'installation page 4

1. Remove underbody panel – Using a flat head screwdriver remove (6) plastic
push rivets from the bottom of the underbody panel. Using a 10mm socket
remove (3) nuts from underbody panel.
3. Install hitch– Remove the stickers from weldnut holes on the frame rail if
present. Use wire brush to clean the weldnuts if needed. Place the spacer
plates on the frame rail in the area of the weldnuts. Raise the hitch into
position. NOTE: BE CAREFUL NOT TO DAMAGE WIRING IN THE AREA OF THE
HITCH. Align the attachment holes in the hitch with the holes in the spacers
and weldnuts, install the supplied bolts and conical washers (Teeth side toward
hitch).
©2022 Horizon Global™ Corp - Printed in Mexico
2. Trim underbody panel and lower fascia – Find the center of the panel and
trim area for receiver. See Figure 2. Find the center of the lower fascia and trim
the area for the receiver. See Figure 3.
NOTE: BE SURE TO CHECK THE AREA FOR SENSOR WIRES THAT MAY NEED TO
BE MOVED BEFORE TRIMMING.
2 ¼"
4. Tighten all M12 fasteners to 76 ft.lb. (103 N*m) with torque wrench.
Proper torque is needed to keep the hitch secure to the vehicle when
.
towing
Sheet 4 of 15 76592NP
3"
Figure 2
3"
1"
Figure 3
04-18-22 Rev. A