Horizon Global 76592 Instructions D'installation page 3

Always wear SAFETY GLASSES
when installing hitch
Frame rail
①②
Conical Washer
Teeth side
Against hitch Figure 1
1. Remove underbody panel – Using a flat head screwdriver remove (6) plastic push rivets from the bottom of the underbody panel. Using a 10mm socket remove (3) nuts
from underbody panel.
2. Trim underbody panel and lower fascia – Find the center of the panel and trim area for receiver. See Figure 2. Find the center of the lower fascia and trim the area for the
receiver. See Figure 3. NOTE: BE SURE TO CHECK THE AREA FOR SENSOR WIRES THAT MAY NEED TO BE MOVED BEFORE TRIMMING.
3. Install hitch– Remove the stickers from weldnut holes on the frame rail if present. Use wire brush to clean the weldnuts if needed. Place the spacer plates on the frame rail
in the area of the weldnuts. Raise the hitch into position. NOTE: BE CAREFUL NOT TO DAMAGE WIRING IN THE AREA OF THE HITCH. Align the attachment holes in the hitch
with the holes in the spacers and weldnuts, install the supplied bolts and conical washers (Teeth side toward hitch).
4. Tighten all M12 fasteners to 76 ft.lb. (103 N*m) with torque wrench.
5. Reinstall trimmed underbody panel.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and exhaust fumes. A hitch or ball which
has been damaged should be removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch. This product complies with safety
specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.
©2022 Horizon Global™ Corp - Printed in Mexico
Installation Instructions
PART NUMBERS: 76592, 84592, CQT76592
Fasteners
typical
both sides
Weldnuts
Spacer plate
Proper torque is needed to keep the hitch secure to the vehicle when towing.
①②
Sheet 3 of 15
Fastener Kit: 76592F
① Qty. (6) BOLT M12x1.25x50mm Cl10.9
② Qty. (6) WASHER CONICAL 1/2"
*Spacer plates are not in the fastener kit,
they are attached to the hitch.
2 ¼"
3"
Figure 2
3"
1"
Figure 3
76592NP 04-18-22 Rev. A