Refrigerator Features; Refrigerator Shelves; Adjustable Meat Tray; Crisper And Crisper Cover - Danby D1866WE Utilisation Et Entretien

REFRIGERATOR
FEATURES

Refrigerator Shelves

The shelves in your refrigerator are adjustable to match
your individual storage needs.
Storing similar food items together in your refrigerator
and adjusting the shelves to fit different heights of items
will make finding the exact item you want easier. It will
also reduce the amount of time the refrigerator door is
open, and save energy.
To remove a shelf:
1. Remove all items from the shelf.
2. Slide shelf straight out aligning the 'shelf stops' on
each side of the shelf with the notches (or openings)
on both sides of foodliner.
3. Lift straight up. The 'shelf stops' will slide through the
notches in the food liner.
4. Slide shelf out the rest of the way.
To replace a shelf:
1. Slide shelf along rail of food liner.
2. Align the 'shelf stops' with the notches (or openings)
on both sides of the food liner .
2. Push 'shelf stops' down through the notches.
3. Slide shelf all the way to the back of the refrigerator.

Adjustable Meat Tray

Your refrigerator is equipped with a meat tray that can be
aligned to the right or left side.
To adjust the meat tray from one side to the other:
1. Remove the meat tray.
2. Remove the shelf that holds the meat tray.
Note: The meat tray has one fixed support. It is the
support that runs down the centre of the shelf.
The other support is the adjustable one.
3. Using a philips (+) screwdriver, unscrew the screw
located on adjustable support.
4. Remove support and attach to preferred side of shelf.
5. Place screw back into adjustable support and fasten.
6. Slide meat tray back into position.

Crisper and Crisper Cover

To remove the crisper:
1. Slide crisper straight out to the stop.
2. Lift the front.
3. Slide crisper out the rest of the way.
Replace the crisper by sliding it back in fully past the
drawer stop.
To remove the crisper cover:
1. Lift cover up and slide out.
2. Replace cover by fitting back of cover against back
wall of cabinet. Then lower front into place.

Light Bulbs

To replace interior light:
1. Unplug refrigerator or disconnect power.
2. Remove light shield by pulling forward slightly and
pulling out.
3. Replace bulb with same wattage appliance bulb.
4. Replace light shield by inserting front tabs into slots
and squeezing shield lightly to insert back tabs into
slots.
5. Plug in refrigerator or reconnect power.
8