Uberhaus 01385000 Guide De L'utilisateur page 5

ASSEMBLY INSTRUCTIONS
2b. Extend the hanger bars to the width of the framing. Position the
fan with the hanger bar tabs wrapped around the bottom edge of the
framing, holding the fan in place. Secure hanger bars to framing using
one screw on each end of hanger bar.Select a proper hole and secure
the hanger bars together using flange screws.
3. ATTACH DAMPER/DUCT CONNECTOR
Snap the damper/duct connector onto the fan housing. The connector
must be flush with the top of the housing, and the damper flap should
fall closed.Insulated flexible duct is recommended for the quietest
possible installation. If rigid duct is used, a short (1-3 feet) section of
insulated flexible duct will ensure quiet operation.
4. INSTALL ROUND DUCTWORK
Connect the round ductwork (not included) to the damper/duct
connector, and run the ductwork to a roof or wall cap (not included).
Using tape (not included), secure all the ductwork connections so that
they are airtight.
The ducting from this fan to the outside of building has a strong effect
on the air flow, noise and energy use of the fan. Use the shortest,
straightest duct routing possible for best performance, and avoid
installing the fan with smaller ducts than recommended. Insulation
around the ducts can reduce energy loss and inhibit mold growth.
Fans installed with existing ducts may not achieve their rated air flow.
CONNECT ELECTRICAL WIRING
Run 120 V AC house wiring to the location of the fan. Use only UL-approved connectors (not included)
to attach the house wiring to the wiring plate. Refer to the wiring diagram, and connect the
wires as shown.
BLACK (BLK)
GROUND (GRD)
FAN
FAN
SWITCH BOX
3
WHITE(WHT)
WIRE
UNIT
PANEL
FAN
RECEPTACLE
POWER SUPPLY
120V AC
SCREW
NAIL
DUCT