I N S T A L L A T I O N
GARDEN AND POND
LED LIGHTS
Aquascape Garden and Pond LED Lights are developed to provide
impressive lighting options for ponds, waterfalls, and landscapes. This
instruction manual will guide you through the proper installation of
Aquascape Garden and Pond Lights as well as recommended maintenance
procedures to ensure long-term effectiveness.
Garden and Pond 1-Watt LED Spotlight
Item #84031
Garden and Pond 1-Watt LED Waterfall
and Up Light
Item #84032
Garden and Pond 3-Watt
Garden and Pond 3-Watt
LED Spotlight
Item #84033
Garden and Pond 6-Watt
Garden and Pond 6-Watt
LED Spotlight
Item #84034
5
TABLE OF CONTENTS
Introduction ................................................... 1
Contents
...................................................... 1
Required Products .......................................... 1
Recommended Products .................................... 1
Safety Information ............................................. 1
Specifi cations Chart
....................................... 2
Installation ................................................... 2-3
....................................... 3
I N S T R U C T I O N S
Required Products
Recommended Products
Safety Information
• To reduce the risk of electrical shock
Find us on:
www.graystonecreations.com 706-865-0220
Contents - #84032
No.
Description
1.
Waterfall and Up Light
2.
Removable Stand
Contents - #84031, #84033, and #84034
No.
Description
1.
Spotlight
2.
Removable Stand
3.
Landscape Stake
12-Volt Transformer
2
1
B
B
A
A
Garden and Pond 3-Way
2
1
Quick-Connect Splitter
(#98489)
2
1
B
B
A
A
Garden and Pond 25'
2
1
Quick-Connect Lighting
Extension Cable
2
(#98998)
B
A
Garden and Pond Photocell
REV
DESCRIPTION
NAME
DATE
PROPRIETARY AND CONFIDENTIAL
THE INFORMATION CONTAINED IN
THIS DRAWING IS THE SOLE
PROPERTY OF AQUASCAPE INC.
ANY REPRODUCTION IN PART OR
AS A WHOLE WITHOUT THE WRITTEN
PERMISSION OF AQUASCAPE INC IS
1
PROHIBITED.
INITIAL RELEASE
EAK
1/15/19
with Digital Timer
2
WARNING: It is
recommended whenever
working in or near water to
have all electrical devices plugged
into a ground fault interrupter (GFCI)
that has been installed by a licensed
electrician.
or damage to the light, all wiring and
junction connections should be made
per local codes. Requirements may vary
depending on usage and location.
1
2
2
1
B
Garden and Pond 6-Way
A
Quick-Connect Splitter
(#84022)
2
1
2
1
B
A
Garden and Pond 25'
2
1
5-Outlet Quick-Connect Lighting
1
Extension Cable
NOTE: TITLE BLOCK TOLERANCE
NOT APPLICABLE
(#84023)
B
A
UNLESS OTHERWISE SPECIFIED:
CREATED BY
EAK
CREATED DATE
1/15/19
TITLE:
DIMENSIONS ARE IN INCHES
PHOTOCELL W/ DIGITAL TIMER
CHECKED BY
CHECKED DATE
TOLERANCES:
FRACTIONAL 1/16
DWG. NO.
ANGULAR: MACH 5 BEND 5
84039-LI-AP-MD-1
TWO PLACE DECIMAL
.010
THREE PLACE DECIMAL
.005
SCALE: 1:4
SIZE
A
SHEET 1 OF 1
INTERPRET GEOMETRIC TOLERANCING PER: ANSI
1
(#84039)
• The power cable should be protected
at all times to avoid punctures, cuts,
bruises, and abrasion.
• Operating the light fi xture outside of
the 9-15 volt operating range voids the
product warranty and may damage or
shorten the life of the LEDs.
IMPORTANT: Aquascape,
Inc. is not responsible for
losses, injury, or death
resulting from a failure to observe
these safety precautions, misuse or
abuse of pumps or equipment.
facebook.com/AquascapeInc
youtube.com/aquascape4
twitter.com/AquascapeInc
1
2
3
B
A
B
A