Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Tools and Parts
TOOLS NEEDED:
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Cordless drill
¹⁄₁₆" and ³⁄₈" Brad point
doweling drill bit
Phillips screwdriver
Rotary tool
PARTS NEEDED:
Custom Overlay Frame—See "Overlay Frame—Rear View."
Hardware (Optional)
PARTS SUPPLIED:
Flat-head screws (8)
Round-head screws (8)
Custom Overlay Frame
If you plan to install a custom overlay frame, you will need to
create the frame yourself or consult a qualified cabinetmaker or
carpenter. See dimension drawings for frame specifications.
IMPORTANT:
The thickness of the overlay frame must be ³⁄₄" (19 mm).
The overlay frame must not weigh more than 10 lbs
(4.54 kg). Overlay frames weighing more than
recommended may cause damage to your appliance.
Overlay Frame Dimensions—Rear View
1. Create a custom overlay frame using the dimensions shown.
2. Rout four depressions into the overlay frame, where indicated,
to attach the overlay hooks.
NOTE: To inlay the overlay hooks into the panel, it is
recommended that you use a rotary tool to rout the surface
where the overlay hooks will be placed.
4
INSTALLATION INSTRUCTIONS
Scissors
Masking tape
Tape measure
Petroleum jelly
Overlay plates (2)
Overlay hooks (4)
⁷⁄₈
4
"
(124 mm)
²⁹⁄₃₂
"
(23.3 mm)
²⁵⁄₃₂
"
(20 mm)
A
¹⁵⁄₁₆
2
"
(75 mm)
¹⁄₁₆
"
(2 mm)
3"
(76 mm)
A. Overlay hook locations
Install Overlay Hooks
Using a Phillips screwdriver and eight flat-head screws, attach the
overlay hooks to the back of the overlay frame. See "Overlay
Frame–Rear View" for overlay hook locations.
A. Overlay hooks (4)
¹⁷⁄₃₂
3
"
(90 mm)
¹³⁄₃₂
"
(10 mm)
⁵⁄₈
23
"
(60.0 cm)
²⁷⁄₃₂
29
"
(75.8 cm)
A
Publicité
Table des Matières
