Residual Risks; Basic Components - Timken ROLLON E-SMART 30 Mode D'emploi

Residual risks

Mechanical risks due to the presence of moving elements (X, Y
■
axes).
Risk of fire resulting from the flammability of the belts used on
■
the axes, for temperatures in excess of 250 °C in contact with
the flame.
The risk of the Z axis dropping during handling and installation
■
operations on the partly completed machinery, before com-
missioning.

Basic components

The Partly Completed Machinery shown in this ca-
talog is to be considered a mere supply of simple
Cartesian axes and their accessories agreed when
the contract is stipulated with the client. The fol-
lowing are therefore to be considered excluded from
the contract:
1. Assembly on the client's premises (direct or final)
2. Commissioning on the client's premises (direct or
final)
3. Testing on the client's premises (direct or final)
It is therefore understood that the aforementioned
operations in points 1.,2., and 3. are not chargeable
Instructions of an environmental
Rollon operates with respect for the envirorment, in order to limit
environmental impact. The following is a list of some instructions
of an environmental nature for correct management of our sup-
plies. Our products are mainly composed of:
Material
Alluminum alloys
Steel with various composition Screws, racks and pinions, and rails
Plastic
Rubber of various types
Lubrification of various types
Rust proof protectione
Wood, polyethylene, cardboard
At the end of the product's life cycle, it is therfore possible to
recover the various elements, in compliance with current regu-
lations on waste issues.
nature
Details of the supply
Profiles, pleates, various details
PA6 – Chains
PVC – Covers and sliding
block scrapers
Plugs, seals
Used for the lubrication of sliding
rails and bearings
Rust proof protection oil
Transport packaging
Risk of the Z axis dropping during maintenance operations in
■
the case of a drop in the electrical power supply voltage.
Crushing hazard near moving parts with divergent and
■
convergent motion.
Shearing hazard near moving parts with divergent and
■
convergent motion.
Cutting and abrasion hazards.
■
to Rollon. Rollon is the supplier of Partly Completed Machi-
nery, the (direct or final) client is responsible for testing and
safely checking all equipment which, by definition, cannot be
theoretically tested or checked at our facilities where the only
movement possible is manual movement (for example: motors
or reduction gears, cartesian axes movements that are not ma-
nually operated, safety brakes, stopper cylinders, mechanical
or induction sensors, decelerators, mechanical limit switches,
pneumatic cylinders, etc.). The partly completed machine must
not be commissioned until the final machine, in which it is to be
incorporated, has been declared compliant, if necessary, with
the instructions in Machinery Directive 2006/42/CE.
Smart System
UM-7