Radio System Corporation BARK CONTROL Manuel De L'utilisateur page 5

Red "No Correction" Caps
The caps are placed over the metal probes to prevent your dog from feeling a
correction. Proper use is described in the Training Section.
Troubleshooting
If your dog continues to bark, test the receiver by dragging the center probe
across a rough surface for at least 10" to 12". It should beep.
If your receiver does not beep during this test
· Make sure protective tape has been removed form the battery module.
· Check battery module for proper fit in receiver.
· Replacement battery module's (RFA-67) are available at your
local vendor.
If your receiver beeps, but your dog does not heed correction
· Use test light to verify correction is being delivered.
· Tighten the collar.
· Trim your dog's hair at the probe contact locations.
Regular Maintenance
· Check battery module for proper fit in receiver (weekly) .
· Check probes for tightness (weekly).
· Clean probes with alcohol (weekly).
· Check your dog's neck for irritation and wash neck (daily).
· Check fit of collar on your dog (daily).
5