Operating Instructions - Drinkwell D360-CA-17 Manuel D'utilisation

operating Instructions

Important: DO NOT RUN DRY - FOR INDOOR USE ONLY.
1. As with any electrical device, check the electrical Power
Cord for any tears, or damage before use.
2. Make sure the In-Line Plug is connected (fig. 1).
3. Remove Cone piece by twisting counter clockwise to
unlock the tabs from the Bowl (fig. 2). Lift up and
set aside.
4. Check to make sure the Intake Tube is properly inserted
(pushed all the way down) into the Pump (fig. 3).
5. Replace Cone and twist clockwise to lock tabs in
place (fig. 4).
6. Take the partially assembled
Filter Housing and remove the
Flow Control Cap by gently
lifting straight up - DO NOT
TWIST TO REMOVE (fig. 5).
Gently lift up and remove the
Spout Ring to access the Filter
Housing Cap.
7. Unscrew Filter Housing Cap and insert the Charcoal Filter into the Filter Housing with
the pull-tab facing up (fig. 6). The Charcoal Filter will slide easily into place. Next,
screw on the Filter Housing Cap (fig. 7).
fig. 5
Important: Rinse the Charcoal Filter thoroughly under cold water before placing into
the housing. This will remove any loose charcoal dust, which is harmless to your pet. A
small amount of charcoal dust may be gradually released for the life of the Filter. This is
normal and not harmful to your pet.
fig. 3 fig. 3
fig. 6
www.petsafe.net
fig. 1
UNLOCKED
fig. 2 fig. 2
LOCKED
fig. 4 fig. 4
fig. 7
7