Maintenance Instructions - AirKing AK55L Manuel D'opération

CAUTION:
FAILURE TO SECURE THE REFLECTOR SCREWS MAY
RESULT IN A RATTLING OR HUMMING NOISE.
6. Install the appropriate bulb (not included) specific to your model:
AK55L: Install a 100 watt maximum, type A19 medium base incandescent bulb (not
included).
AKF55: Install an Air King model 26SBL or a compatible GU24 26 watt self ballasted
lamp (not included).
7. Close the light lens and secure in place by swinging back into position and snapping the
tabs in place (Figure 13).
Connector
Bar
Figure 13
8. Restore power and test your installation.
SECTION 7
Operating Instructions
WARNING:
BEFORE IT IS USED.
1. Each function of the heater is controlled via the wall switches described in SECTION 5 of
these instructions.
2. This unit utilizes a thermal fuse mounted to the heating element housing. DO NOT tamper
with this device.
3. This unit utilizes a manual reset control mounted to the heating element housing. DO
NOT temper with this device.
4. The manual reset control will disable the heater portion of this unit if a high temperature
is detected. To reset this device, interrupt power to the entire unit via the wall switches
or service panel for at least 15 minutes. Prior to using the unit again, clean the unit
as described in Maintenance Instructions portion of these instructions. If this control
actuates again, seek the services of a qualified electrician before using unit again.
210575055 Rev. G 12-15
Tabs
HEATER MUST BE PROPERLY INSTALLED
SECTION 8

Maintenance Instructions

NOTE: Grill and fan should be cleaned when dust accumulation becomes visible on grill or
every 6 months.
1. Cleaning the Grill: Reverse the instructions in Section 6 Completing the Installation to
remove grill. Use a mild detergent, such as dishwashing liquid, and dry with a soft cloth.
NEVER USE ANY ABRASIVE PADS OR SCOURING POWDERS. Completely dry grill before
reinstalling. Refer to instructions in Section 6 Completing the Installation, to reinstall grill.
2. Cleaning the Fan Assembly: Wipe all parts with a dry cloth or gently vacuum the fan.
NEVER IMMERSE ELECTRICAL PARTS IN WATER.
NOTE: Motors in this unit are permanently lubricated. Do not add lubricant.
WARNING:
PERFORMED BY AN AUTHORIZED SERVICE REPRESENTATIVE.
CAUTION:
Changing the Light Bulb: Disconnect power to the unit. Open light lens by pushing in on
3.
the two tabs of light lens and pulling outward from lens. The lens will swing open on the
connector bars. DO NOT remove the lens from the grill (Figure 13).
Incandescent Bulb (AK55L): Unscrew bulb from lamp holder and replace with a 100
watt maximum, type A19 medium base incandescent bulb.
Fluorescent Bulb: Install an Air King model 26SBL or a compatible GU24 26 watt self
ballasted lamp (not included) into the lamp holder by lining up the pins on the lamp base
to the socket of the lamp holder and turning the lamp body clockwise until the lamp
snaps into place and is firmly seated in the lamp holder.
CALIFORNIA RESIDENTS ONLY:
WARNING:
CHEMICALS] KNOWN TO THE STATE OF CALIFORNIA TO CAUSE CANCER.
WARNING:
CHEMICALS] KNOWN TO THE STATE OF CALIFORNIA TO CAUSE REPRODUCTIVE
TOXICITY.
www.airkinglimited.com
CAUTION:
MAKE SURE POWER IS SWITCHED OFF AT
SERVICE PANEL BEFORE STARTING INSTALLATION.
ANY OTHER SERVICING TO THIS UNIT SHOULD BE
ALLOW BULB TO COOL BEFORE REPLACING.
THIS PRODUCT CAN EXPOSE YOU TO A CHEMICAL [OR
THIS PRODUCT CAN EXPOSE YOU TO A CHEMICAL [OR
4 of 12