Aguilar AG 700 Mode D'emploi page 5

D.I. Section:
D.I. Nominal Output Level: -20 dBu
D.I. Pre/Post Button:
Pre - Your signal goes to the D.I. XLR output jack before your Gain and
EQ settings, but after the –10 dB input pad.
Post – Gain, EQ, and effects will be sent to the D.I. XLR output jack. In this
setting adjustments to the Master control will only affect the output to
your speaker cabinets, not the signal going to the D.I.
Lift/Ground: If there is a hum when using the D.I. there may be a
ground loop. In many cases pushing in the Lift/Ground button can fix
this problem.
The AG 700 can be run safely without a speaker load attached to the
amplifier for recording through the XLR output. Simply remove the
speaker cables from the rear panel speakon jacks and then run a cable
from the XLR output to your recording device/interface.
* Note: The AG 700 will not be harmed by phantom power through the
DI. D.I. Phantom power is a power supply that can be switched on at
the channel input of some mixing consoles and is used to power some
types of microphones. Use of phantom power (usually labeled as 48V)
will have no effect on the D.I. or the amplifier in general.
B. Rear Panel Features
Speaker Outputs:
Two speakon outputs are provided. Any combination may be used as
long as the load does not go below 2.67 ohms. The speakon jacks are
wired +1, -1.
Tuner Output:
One ¼" Tuner output is provided. When the amplifier is muted your
signal will still reach the tuner.
Page 5