Kohler K-942 Mode D'emploi page 3

Apply Plumbers
Putty
Putty Ring
(if included)
1. Spout Installation
Apply a bead of plumbers putty or other sealant to the underside
of the spout or putty ring (if supplied) according to the putty
manufacturer's instructions.
Locate the center hole and insert the spout.
Position the metal washer so the second hole lines up with the
drain lift rod hole on the back of the spout.
Securely tighten the nut with a wrench. Do not overtighten.
Remove any excess putty or sealant.
Kohler Co.
Nut
Metal
Washer
3 1009772-2-B