Installing The Batteries To The Remote; Connect Power & Antenna/Cable/Satellite; Switching On/Off; First Time Installation - Mobile TV MTV 19 SAT Mode D'emploi

Installing the Batteries to the Remote

1. Lift the cover on the back of the remote upward
gently.
2. Install two AAA batteries. Make sure to match the +
and - ends of the batteries in the battery compartment
(observe the correct polarity.
3. Replace the cover.
Connect Power & Antenna/Cable/Satellite
IMPORTANT: The TV set is designed to operate on 12
V DC. For this, an adaptor is used which gives 12 V
voltage. Connect this adaptor to a system that supplies
110-240V AC, 50/60Hz. After unpacking, allow the TV
set to reach the ambient room temperature before you
connect the set to the mains.
13V dc /18V dc
VGA
SPDIF
To POWER
INPUT DC 12 V
terminal
AC adapter

Switching On/Off

To Switch the TV On
Connect the power cord to the 110-240V AC,50/60Hz.
Then the standby LED lights up.
To switch on the TV from standby mode either:
Press the " " button, CH ^/ v or a numeric button on
the remote control.
Press the control switch located on the left side of the
TV. The TV will then switch on.
Satellite
Aerial or Cable
DiSEqC
Switch
13V dc /18V dc
VGA
SPDIF
English - 10 -
To Switch the TV Off
Press the " " button on the remote control or press
and hold the control switch on the TV until the TV
shuts down, so the TV will switch to standby mode
(Depends on the model).
To power down the TV completely, unplug the power
cord from the mains socket.
Note: When the TV is switched to standby mode, standby LED
can blink to indicate that features such as Standby Search,
Over Air Download or Timer is active. The LED can also blink
when you switch on the TV from standby mode.

First Time Installation

NOTE: If you are going to perform FRANSAT
installation, insert the FRANSAT card (optional) into
the Conditional Access terminal of your TV before
switching on your TV.
When turned on for the first time, the "language
selection" menu appears. The message "Welcome
please select your language!" is displayed in all
language options listed alphabetically.
Press the " " or "
language, press OK button to select. "First Time
Installation" appears. Use "
required country, and press "
Type. Use " " or "
Available search types are Digital and analog, digital
only and analog only. When set, press "
Teletext Language. Use "
"Teletext Language" and select "Scan Encrypted" using
" " or " " button. You can set Scan Encrypted as
Yes if you want to scan coded stations.
" button to highlight the required
" or " " button to set the
" button to select Search
" to set the desired search type.
" to select
" or " " button to set the