Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
BEFORE FIRST USE
This portable ice maker uses a fully-automatic control system, with an
advanced microcomputer for easy and convenient ice making. Making ice is
simple and fast. Just add water, plug into an outlet, and press the ON/OFF
button. You can select one of the two ice cube sizes with the touch of a button.
When first turning on the unit or during ice-making cycles, the compressor will
stay idle for 3 minutes, while energizing.
There are warning indicators that alert you to fill water when the reservoir is
empty, and to remove ice when the storage basket is full. The icemaker also
has built-in safeguards that can limit accidental damage, automatically shutting
down the system when necessary.
Please read carefully.
1.
The incline angle of the ice maker cabinet should not exceed 45˚ during
transportation or use. Do not turn the icemaker upside down.
Inverting the ice maker could cause the compressor or refrigerating system to
operate incorrectly. When the ice maker is moved or transported, please allow
time for the fluids in the compressor to settle. Before using the ice maker for
the first time, please wait 2 hours after the unit has been leveled and positioned
in its proper place.
2.
Please ensure the ice maker is level and on a stable table or platform
to avoid malfunction.
3.
The machine must be placed on a dry and level surface with sufficient
ventilation, far from heat sources such as ovens, heaters and corrosive gases.
Leave an 8" (20 cm) clearance on all sides of the ice maker for proper
ventilation.
4.
Do not fill the water reservoir with hot water. This may damage the ice maker.
It is best to fill the water reservoir with water of room temperature or lower.
USE YOUR ICE MAKER
1.
Ensure that the drain plug underneath the front of the unit is closed and
the water tube screen is in place.
2.
Plug the ice maker into the wall outlet and the green power indicator light
will blink (approximately every 5 seconds).
3.
Open the cover and remove the ice basket.
4.
Fill the water reservoir. NOTE: do not fill above the max water level
mark at the back of the water reservoir.
5.
Replace the ice basket and close the cover.
4
Publicité
Table des Matières
