Napier 84000 Mode D'emploi page 3

ATTACHING TO YOUR VEHICLE
6) From inside the tent, unzip the door and mesh that
faces the vehicle to access the cargo area. Roll up
mesh and secure with the T-straps.
A) Move the tent towards the cargo area of the vehicle.
Slip the sleeve under the bumper and over the roof.
B) Hook the bottom outside strap to any part of the wheel
well and tighten the strap. Repeat on opposite side.
C) Ensure the exhaust pipe is outside the sleeve.
WARNING: Carbon Monoxide gas is dangerous
and can cause unconsciousness or death. Never
start or run the vehicle's engine when the tent
is attached to the vehicle.
© 2011 Napier Enterprises – All Rights Reserved.
Rev. 00 11.10.10
7) Attaching the vehicle roof straps.
A) WITH A ROOF RACK, remove the long strap from the
female chip. Attach the 2 short straps around the
roof rack. Repeat on the opposite side and tighten
straps to secure tent.
B) WITHOUT A ROOF RACK, extend the long straps to the
front of the vehicle. Open the hood and attached the
hooks to the hood hinge or frame. Tighten the straps to
secure the tent.
8) From inside the tent, attached the center hook to the
tailgate latch. For the 2 outer hooks, attach them to the
cargo bag hook or to the tailgate latch.
OR
3 of 10