Bimar Prontoforno JK-2001C Mode D'emploi page 16

All manuals and user guides at all-guides.com
Fax +32 030 9904733
service centre and make sure that the parts supplied are
original.
Warning: In order to avoid overheating, do not cover the
•
appliance.
INSTALLATION
•
After removing the packing materials, check the integrity of the appliance; if
you are unsure, do not use it and ask for qualified professional help. The
packing materials (plastic bags, polystyrene foam, nails, etc.) must be kept out
the reach of children because they are potential sources of danger; dispose of
them according to
differentiated collection. Attention: any stickers or advertising material
applied to the door must be removed before using the appliance. The
manufacturer declines all responsibility in case this is not safe working
practices will be respected.
•
Before connecting the appliance, check that the voltage shown on the data
plate matches that of your electricity, and that the electric plug is grounded
(the manufacturer declines any responsibility for the lack of observation of this
norm).. In the event of incompatibility between the electric outlet and the plug
of the appliance, have the outlet replaced with another more suitable type by
professionally qualified personnel, who will make sure that the section of the
wires of the outlet is appropriate for the absorbed power of the appliance. In
general, the use of adapters or extension cords is not recommended; if their
use is indispensable, they must conform to existing safety standards and their
current capacity (amperes) must not be less that the maximum of the
appliance.
•
The appliance must not be placed directly beneath a plug point.
•
The plug point must be easily accessible so as to easily remove the plug in
case of an emergency.
•
Each time before use, check that the appliance is in good condition and that
the electric cord is not damaged: if in doubt, ask for professionally qualified
help.
•
It is recommended to keep the appliance away from the edge of the work
surface and out of reach of children.
•
Make sure that the cable is correctly positioned, that it is not touching hot
elements or sharp edges, is not wound around the utensil, is not twisted up on
itself or in the way, so the appliance cannot tip over.
•
Place the appliance:
far from other sources of heat (for example, other ovens, gas hobs, etc.),
-
inflammable materials (wallpaper, etc.), explosive materials (spray cans)
and materials that would become deformed when heated.
- on a flat and stable work top and not on delicate surfaces (painted furniture,
tablecloths, etc.), in a position where it cannot be bumped, and at a
suitable distance from the edge so that it cannot fall.
- far from containers of liquids, such as sinks, etc. Should it unexpectedly
become wet or fall in a liquid, remove the plug immediately from the
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in
order to obtain a booklet A5 (+/- 148.5 mm width x 210
mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't
change the page numbering. Keep the language
integrity.
current regulations, in
16 48
/
Assembly page 16/48
dedicated containers for