Remote Control - ferolli LIRA SLIM LA10A00A Manuel D'installation, D'utilisation Et D'entretien

4.6 Menu
Press button P1 to access the menu. It is divided into eleven sub-menus for accessing the settings of the electronic
control.The various sub-menus can be scrolled by pressing buttons P1 and P2, and can be accessed by pressing
button P3.
4.6.1 Menu M1 – not present
4.6.2 Menu M2 – not present
4.6.3 Menu M3 – select language
With this selection it is possible to set the desired language from those available.
4.6.4 Menu M4 – standby mode
Entering with button P3 and adjusting with buttons P1 and P2 you can activate or deactivate the STAND-BY mode.
By selecting ON in STANDBY mode the corresponding symbol on the display lights up and the stove shuts down
automatically when the room temperature has reached the set value for a given time.
The next restart in automatic will be possible only when the room temperature falls below the set value by a few
degrees (default 2°C). With the OFF selection, the modulation function is active but not the STANDBY mode.
Therefore when the temperature exceeds the set value the stove will operate at minimum power.
4.6.5 Menu M5 – buzzer
With this selection it is possible to activate or deactivate the stove alarm buzzer.
In order to activate or deactivate press the buttons P1 and P2, to confirm press button P3.
4.6.6 Menu M6 – initial loading
It allows the preloading of pellets for a given time. This function can only be activated when the stove is off and cold
and is used if the auger is empty due to no more pellets.
Once the menu is selected, push the button P2 to activate the auger at its maximum speed for a preset time. In
order to stop it, push button P3.
4.6.7 Menu M7 – stove status
This selection is reserved exclusively for the authorised service centre technician.
4.6.8 Menu 08 – settings by technician
This selection is reserved exclusively for the authorised service centre technician.
Modification of the technical parameters of menu 08 must be done by an authorised and competent
technician; any modifications made randomly can cause serious damage for which declines any liability.
4.6.9 Menu M9 – exit
By selecting this menu and then pushing button P3 you exit the menus and go back to the normal visualisation.

4.7 Remote control

The remote control works with the settings made in the control panel and allows stove lighting-shutdown, and
adjustment of the required output and temperature.
Since this device transmits through an infrared diode, it must be pointed at the receiver unit in the control panel.
The remote control allows the following operations:
P5 - COMFORT function: pressing this button forces power and ventilation onto P1. Deactivating this function will
take the power and ventilation to the value prior to activation.
This function observes and performs STANDBY.
P6 - QUICK function: pressing this button forces the machine power onto P5, saving the previous set power.
Ventilation, too, if present, is forced onto AUTOMATIC (so maximum ventilation); saving the previous ventilation
value. When pressed with the comfort function activated, it restores power and ventilation to the previous saved
value. With set ambient or set water satisfied the heater modulates P1 power together with ventilation.
P7 - MAGIC CLEANING function: pressing this button while the machine is working will force BRAZIER CLEANING.
When OFF, activating this function will put the machine into FINAL CLEANING. From the state of FINAL CLEANING,
if this button is pressed again it will discharge the FINAL CLEANING timer thus leaving intact the safety checks on the
flue gas temperature.
P8 - TURBO function: like the QUICK function with the difference that the heater does not modulate P1 power with
set ambient or set water satisfied but modulates only in the flue gas safety condition.
37 LIRA SLIM