Medistrom Co-Pilot 12 Guide De Démarrage Rapide page 2

Connecting the Co-Pilot
Note:
It is important to perform the following steps in order. If
these steps are not performed in the order listed below the Co-
Pilot may emit an error code. To clear this error code please
disconnect all cords from the Co-Pilot and Pilot Plus and then
power cycle the device and follow the instructions as they are
written below.
Uninterruptible Power Supply (Backup Battery)
1. Secure the Co-Pilot and Pilot batteries together using the two
rubber joiners included with the Co-Pilot. Please ensure that
the Pilot battery (not included with Co-Pilot package) is in the
LOWER slot and the Co-Pilot is in the UPPER slot and that the
front of each battery is facing the same direction when joined
together.
2. Connect the
the Pilot Plus CPAP battery using the DC Cable that is included
in the Co-Pilot package.
port on the Co-Pilot to the
OUTPUT
jack on
CHARGE
2