Installation; Installing Your Television Set; The Keys On The Tv Set - Philips 21PT6818/58 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 19

Installing your television set

&
Positioning the television set
5 cm
Place your TV on a solid, stable surface, leaving
a space of at least 5 cm around the appliance.
To avoid accidents, do not put anything on the
set such as a cloth or cover, a container full of
liquid (vase) or a heat source (lamp).The set
must not be exposed to water.
é
Connections
FM.
ANT.
• Insert the aerial plug into the : socket at
the rear of the set.
• Insert the radio aerial socket into the FM
ANT socket using the adapter supplied.
If you are using an indoor aerial, reception may be
difficult in certain conditions.You can improve
reception by rotating the aerial. If the reception
remains poor, you will need to use an external aerial.
• Insert the mains plug into a wall socket (220-
240 V / 50 Hz).

The keys on the TV set

The television set has 4 keys which are located
on the front or the top of the set depending
on the model.
-
VOLUME
2
5 cm
5 cm
+
-
+
PROGRAM
"
Remote control
Insert the two R6-type batteries (supplied)
making sure that they are the right way round.
Check that the mode selector is set to TV.
The batteries supplied with this appliance do
not contain mercury or nickel cadmium. If you
have access to a recycling facility, please do not
discard your used batteries (if in doubt,
consult your dealer).When the batteries are
replaced, use the same type.
'
Switching on
To switch on the set, press the on/off key.
A red indicator comes on and the screen
lights up. Go straight to the chapter Quick
installation on page 4.
If the television remains in standby mode,
#
press P
on the remote control.
The indicator will flash when you use the
remote control.
"
The VOLUME - + (-
adjust sound levels.The PROGRAM - + (- P +)
keys are used to select the required programmes.
To access the menus, simultaneously hold down
"
"
the
- and
+ keys.The PROGRAM - +
keys may then be used to select an adjustment
"
and the -
+ keys to make that adjustment.
To exit from the menus, hold down the 2
"
and
+ keys.
Note: when the Child Lock function is activated,
these keys are unavailable (refer to
menu on page 7).
+) keys are used to
"
-
Features

Publicité

Table des Matières
loading

Table des Matières