Connecting Peripheral Equipment; Video Recorder; Other Equipment; To Select Connected Equipment - Philips 21PT6818/58 Mode D'emploi

Connecting peripheral equipment

Depending on the versions, the TV set will be equipped with 1 or 2 SCART connectors EXT1 and
EXT2 located on the rear. The EXT1 socket has audio, CVBS/RGB inputs and audio, CVBS outputs.The EXT2
socket (if available) has audio, CVBS/S-VHS inputs and audio, CVBS outputs.

Video recorder

Other equipment

Amplifier
4 5 6
7 8 9
Á
Ø 0
16
Carry out the connections shown opposite, using a good
quality euroconnector cable.
If your video recorder does not have a euroconnector socket, the
only connection possible is via the aerial cable.You will therefore
need to tune in your video recorder's test signal and assign it
programme number 0 (refer to manual store, p. 6).
To reproduce the video recorder picture, press
Video recorder with decoder
Connect the decoder to the second euroconnector socket
of the video recorder.You will then be able to record
scrambled transmissions.
Satellite receiver, decoder, CDV, games, etc.
For TV sets with 2 SCART connectors, preferably connect
the equipment delivering RGB signals (digital decoders, DVD
players, games consoles, etc.) to EXT1 and the equipment
delivering S-VHS signals (S-VHS and Hi-8 VCRs) to EXT2.
To connect to a hi-fi system, use an audio connection cable
and connect the "L" and "R" outputs on the TV (only
available on certain versions) set to the "AUDIO IN" "L" and
"R" input on your hi-fi amplifier.
Use a digital audio connecting cable and connect the
television's "DIGITAL AUDIO OUT" output to a "DIG IN"
input on the amplifier (amplifier with coaxial digital input).

To select connected equipment

n
Press the key to select EXT1 and on the versions with 2 scarts,
EXT2, S-VHS2 (S-VHS signals from the EXT2 socket) and AV for
the side connections (if available).
Most equipment (decoder, video recorder) carries out the switching itself.
0
.