Warming Mode Instructions - Newteck Rhapsody dual 365 Mode D'emploi

TIMER
Press the timer button on the remote control to set the time
from 1 to 8 hours.
Signal receiver
due to overlapping of the of the remote control's frequencies:
1. This fan can react when a control for other devices is used.
2. By using this fan's control, other electrical appliances may react.
The switch on the remote control will put this fan on hold but will not turn
it off completely. Use the main unit switch to turn off the fan completely
when not in use.
If this fan is not in use for a long time, disconnect the power cord.

- WARMING MODE INSTRUcTIONS -

Ambient
temperature
48
Warm mode: use the remote control
to set the temperature, the main body
does not support this operation.
Programmed
Press the "Heat mode" button and
temperature
the display will show the ambient
temperature.
Press the "Temperature rise" button
and the screen will flash digitally. You
can set the temperature between 1-30
°C.
The remote control should
be pointed at the signal
receiver on the screen to
maximize the
control signal.
Effective distance:
meters.
Warning:
You must take
account the
phenomena that occur
when using
device's control that is
remote
5
into
following
the the