Safety Cable; Installation Of Safety Support - Hinkley 900972FMM-NWA Manuel D'instructions

REMEMBER
to turn off the power before you begin.
To properly install your ceiling fan, follow the steps below.
6
Slip the yoke cover, trim ring and canopy onto the downrod. (Fig. 3)
Slide the hanger ball onto the downrod, insert the cross pin through
the downrod and tighten. Tighten the set screw.
7
Feed wires through holes in rubber ball moisture cap and slide cap
down over top of ball. (Fig. 3)
8
Lift ball/downrod/fan into hanger bracket opening.
NOTE: The tab opposite hanger bracket opening should fit in slot
9
on ball. (Fig. 4)
NOTE:
6 feet of lead wire is supplied on the fan for use with
longer downrods.

INSTALLATION OF SAFETY SUPPORT:

Attach the lag bolt and flat washer to ceiling joist.
Attach the safety cable to lag bolt. Slide cable
clamp onto safety cable (from fan). Place the
end of cable through the lag bolt. Pull as much
cable through lag bolt as possible. Feed end of
cable into clamp hole and firmly tighten screw
(Fig. 4). Cut off excess safety cable.
Cross Pin
Hanger Ball
Set S0crew
Hook-up (3) Wires
Downrod
Yoke Cover
Top of
Fan Body
Fig. 3
Hanger bracket

Safety cable

Safety cable clamp
Fig. 4
©2019 Hinkley Lighting, Inc. | hinkley.com |
Safety Cable
Ball Moisture Cap
Ground Wire
Canopy
Trim Ring
07