Beem DYNAMIC i-POWER Notice D'utilisation page 31

EN
Fault
Steam diminishes or
no steam
Stains in ironed
washing
Calcium particles
leak out of the steam
nozzles
Washing remains
creased
Singed areas on the
ironed washing
House safety fuse is
triggered
NOTE
► If you cannot resolve the problem with the steps described above, please contact
customer service.
BEEM - Elements of Lifestyle
All manuals and user guides at all-guides.com
Possible cause
Reduce temperature
Water tank empty
Iron is calcified
Steam ironing not set
Water in tank is discol-
oured
Iron is calcified
Temperature too low
Temperature too high
Appliance defective
Too many appliances con-
nected.
DYNAMIC i-POWER
Remedy
Wait for a few seconds
Fill with water
Perform self-cleaning
Set the desired steam flow with
the steam flow regulator
Always empty the water tank
after use
Perform self-cleaning
Set temperature as high as pos-
sible. Pay attention to the label in
the garment!
Set temperature lower and allow
iron to cool down Pay attention
to the label in the garment!
Contact customer service.
Reduce the number of appli-
ances on the power circuit.
29