Technical Data - Beem DYNAMIC i-POWER Notice D'utilisation

EN
Fill the water tank (12) up to about
‹
a half with water as described in the
Filling with water section. It is rec-
ommended only to use distilled water
for self-cleaning.
Insert the plug of the appliance into
‹
the mains socket. The control indica-
tor (11) light ups.
Turn the temperature regulator (13) to
‹
the "MAX" position.
The temperature indicators (9) light up
on both sides of the appliance during
heat-up.
Wait until the appliance has heated
‹
up, the control indicator (11) flashes
and the temperature indicators extin-
guish.
Set the temperature regulator (13) to
‹
the "OFF" position.
Pull the plug out of the mains socket.
‹
Hold the appliance horizontally over a
‹
wash basin or similar.
Press the self-clean button (15).
‹
Allow the the water tank to empty
‹
completely. Lightly tilt the appliance
back and forth so that the water can
run out of all nozzles.
Repeat the cleaning procedure as
‹
often as necessary until no calcium
deposits come out of the nozzles.
If necessary, briefly switch on the ap-
‹
pliance to allow residual amounts of
water to evaporate.
NOTE
► It is not necessary to decalcify the
appliance separately.
BEEM - Elements of Lifestyle
All manuals and user guides at all-guides.com
DYNAMIC i-POWER

Technical data

Model
Type number
Red-metallic
Violet-metallic
Dimensions (W x
H x D)
Approx net weight.
Operating voltage
Mains frequency
Power consump-
tion
Protection class
Type of protection
Water tank
capacity
Steam iron
DYNAMIC i-POWER
D4,001
D4,002
310 x 135 x 155 mm
1.4 kg
220-240 V~
50/60 Hz
2600 W
I
IP X0
0.35 litre
27