Connecting Power Cord - FS M6200 Série Guide De Démarrage Rapide

Connecting Power Cord

1. Plug AC power cord into the power port on the front panel of AC power module.
2. Connect the other end of the power cord to an AC power source.
WARNING:
Connecting to the Management Ports
SFP Management Port
1. Plug the compatible SFP transceiver into the SFP port on the front of NMU module.
2. Connect a ber optic cable to the transceiver. Then connect the other end of the cable to another
ber device, such as a switch.
Do not install power cables while the power is on.
16